Anyone who resin prints with Chitubox this will reduce pritn time at least by half and will also make more reliable at some time "not vroom" (Patreon)

I am making a video as well but i have been using resin printers to make test parts for the Troodon and i found a complete lack of good info on the actual slicer settings and all this vroom stuff. So the issue is we are able to set the lift and retract in chitubox which actualy only sets the initial lift speed then it goes to the firmware setting for the rest of the way up and then retract does the opposite so i found that instead of vroom which will make it go fast and rip the part off the FEP for the first mm or 2  then go slow i did the opposite. I also made a decoded gcode file that sets the firmware values. You can run the backup gcode file attached to make a stockeeprom file that will be your backup then you can open this file and use my file to decode. My file is set for a LD006 and i have an LD002r and a sonic mini 4k but Just edit your file using mine to decode it . Or better is upgrade to chitubox 1.9 making sure to upgrade to newest firmware from your printer manufacturer and then you can now set both speeds just beware that the manual and guide is wrong so you will want to watch the video i made that explains and shows the speed change. Now the only benefit to 1.9 over my firmware mod is that now the slicer will show a more accurate time cuas ei managed to take 4hr prints and turn them into a little over 1 hr. Ill edit and add the link to the video when i am done editing it but this is the link to creality ld006 firmware and ld002r. https://drive.google.com/drive/folders/1TNsSRvuTOFyQgJHhwlRZCbPQwvneXCHb?usp=sharing